(pictures will follow)

I wanted to create software for this programmer so that it could again be used from a PC.

...

The first part of the transfer works OK. I need to send a 'T' to start the process. Then I need to wait for a confirmation sent by the device. The device checks which slots contains EPROMs and checks their type which takes about 5 seconds. After that I receive either a SOH (0x01) indicating all is well, or a CAN indicating there is some error. That all works.

...

After that I should start sending Intel HEX records one by one; after each record I should receive either a NAK or an ACK. This part, however, never works… The device always remains with “RECEIVE” on its display and that is the end of things.

...

So, next step: logic analyzer

...

The logic analyzer

I connected my 16702A to the EPROM so that I could read what the device was doing. As an initial test I measured what the thing did when it was at RECEIVING and not doing anything else anymore. The LA display showed this:

...